3 inch core drill hole for electrical panel

Price - $400

nccoredrill avatar

Phone: 704-245-0119

Event/Project Location: Charlotte NC

7863 times displayed

2020-10-17 16:13:23

Last Updated: 2020-10-17 16:13:23

Just to show that often homeowners and residential contractors also need core drilling at times, we exhibit the following pictures to prove that it does happen. This is a small project on Hempstead Place in Charlotte, NC. It was a considerable thick concrete wall at 12-inches for a garage, even if it was a two story one. It took about 1 gallon of water to core drill this wall with the Milwaukee 4097 core drill motor. These motors are designed to run a little higher RPM to holes from 1 to 4 inches in core drill bit width.