2 inch core drill bit

core drilling over 500 two inch holes in a concrete floor

services 2 inch

core drilling over 500 two inch holes in a concrete floor

Speed is the key to completing a large core drilling project. keeping the core drill bit sharp and cutting at top efficiency is an enormous responsibility of any core drill operator who has the goal of cutting as many holes in a workday as possible when the opportunity presents itself. One of the things about core drilling holes in concre...

concrete cutting 2 inch bit

products 2 inch

concrete cutting 2 inch bit

Price $90

This is a great picture of a mess of core drill bits that we just got in this week. Shown is a 5 inch core drill bit, surrounded by various smaller bits. If you are in need of a concrete cutting 2 inch core drill bit then you have reached the right place. All of our core drilling bits drill to a depth of 14 inches with a single pass. Ext...

core drilling water basin for retention pond

services 2 inch

core drilling water basin for retention pond

Here we core drilled 2 two inch holes into the water basin of a retention pond off highway 49 in Harrisburg, NC. The area has seen much growth over the past 30 years and this particular job was to satisfy the Charlotte city engineers to make sure the pond drained correctly in case there cme one of those 100 year floods that happens every ...

2 inch hole in wall with rig

services 2 inch

2 inch hole in wall with rig

This is our very useful small core drill rig core drilling a 2 inch hole into a concrete tilt wall at about 7 foot off the ground. The job was in Fort Mill, SC. A small town south of Charlotte, NC. This is our very simple way of getting the core drilling rig to where the core drill hole needs to be placed on the concrete wall. Not everybo...

core drilling 2 inch holes for electric panel

services 2 inch

core drilling 2 inch holes for electric panel

This is an artsy picture of some 2 inch core drill hole on a wall where the contractor wanted the holes to be lined up vertically up the wall. It was quite a chore the get the exact pattern to set and reset the core drill rig each time....